Description
- Weight: 6.0 lb
Secure wire rope terminations with the Campbell Electrogalvanized Malleable Iron Wire Rope Clip. Lock down 1/4 in cable quickly and keep assemblies reliable in the weather with a corrosion-resistant electro-galvanized finish. Count on a solid grip that helps your lines stay tight on posts, anchors, and hardware.
Key Features
- Malleable iron body: Delivers a firm, consistent clamp under everyday jobsite loads.
- Electro-galvanized finish: Helps resist rust on outdoor installs and damp sites.
- 1/4 in trade size: Fits common guy lines, fencing runs, and light rigging setups.
- Reliable hardware interface: Smooth saddle and clean threads support even torque and repeatable results.
- Coating guidance: Use with bare wire rope only. If working with jacketed cable, remove the jacket where the clip seats. Coated cable use is not recommended.
Applications
Build loop ends, secure return legs, and tension lines on posts, anchors, and temporary barriers. Outfit site fencing, signage, and utility tie-backs where a dependable clamp is required. Carry a few to each job; the listed 6 lb package weight makes stocking and transport straightforward.
Installation Notes
- Position correctly: Place the saddle on the live end of the rope.
- Tighten evenly: Torque nuts evenly, then recheck after initial load and again after use.
- Follow instructions: Refer to manufacturer assembly and torque guidance for your rope size.
Specifications
- Style: Wire rope clip
- Material: Malleable iron
- Trade size: 1/4 in
- Finish: Electro-galvanized
- Figure no.: 3300
- Weight: Approximately 6.0 lb
Inspect regularly and replace if worn or damaged to maintain holding strength.